|
- # http://omap.spectrumdigital.com/osk5912/
-
- source [find target/omap5912.cfg]
-
- # NOTE: this assumes you're using the ARM 20-pin ("Multi-ICE")
- # JTAG connector, and accordingly have J1 connecting pins 1 & 2.
- # The TI-14 pin needs "trst_only", and J1 connecting 2 & 3.
- reset_config trst_and_srst separate
-
- # NOTE: boards with XOMAP parts wire nSRST to nPWRON_RESET.
- # That resets everything -- including JTAG and EmbeddedICE.
- # So they must use "reset_config srst_pulls_trst".
-
- # NOTE: an expansion board could add a trace connector ... if
- # it does, change this appropriately. And reset_config too,
- # assuming JTAG_DIS reroutes JTAG to that connector.
- etm config $_TARGETNAME 8 demultiplexed full dummy
- etm_dummy config $_TARGETNAME
-
- # standard boards populate two 16 MB chips, but manufacturing
- # options or an expansion board could change this config.
- flash bank osk.u1 cfi 0x00000000 0x01000000 2 2 $_TARGETNAME
- flash bank osk.u2 cfi 0x01000000 0x01000000 2 2 $_TARGETNAME
-
- proc osk5912_init {} {
- omap5912_reset
-
- # detect flash
- flash probe 0
- flash probe 1
- }
- $_TARGETNAME configure -event reset-init { osk5912_init }
-
- arm7_9 dcc_downloads enable
|